connect TFT 2.2” screen to Raspberry Pi B+ and 2

The short URL : http://www.ezenow.com/rsttU

1 ENABLE SPI from rpi-config

2 WIRE

Becareful with breakout kit direction (see picture)
Wiring for TFT 2.2” screen and Raspberry Pi B+ and 2
MISO – MISO
LED – GPIO18 (#18)
SCK – SCLK
MOSI – MOSI
DC/RS – GPIO 24 (#24)
RESET – GPIO 25 (#25)
CS – CE0
GND – GND
VCC – 3.3V

To start GUI for TFT Screen when everything is done: sudo FRAMEBUFFER=/dev/fb1 startx — -dpi 60

The short URL : http://www.ezenow.com/rsttU
WordPress SEO fine-tune by Meta SEO Pack from Poradnik Webmastera